Loublet Schematic

Showing posts with label Simulator. Show all posts

Thursday, October 2, 2014

This signal is then buffered by gates N3 . . . N6 and the balanced output A stage gives a level sufficient to drive a small loudspeaker. ln spite of the current consumption of 65 mA, a standard 9 V battery (preferably alkaline-manganese) will suffice, because tuning forks are by their nature used for short periods only. lf the fork is used for longer periods, it might be advisable to consider a rechargeable battery.
An oscillator, a divider, a loudspeaker and a battery are all that is required. T0 be useful, an electronic tuning fork must, of course, be a compact unit.
As the use of special, and therefore oostly, crystals was precluded, a little research showed that it would be possible to use relatively simple and standard components.
The oscillator is constructed a- round gates N1, N2 and tuned to 1,000,120 Hz (with a frequency counter if possible), by means of trimmer C2.
A standard tuning fork produces a tone of 440 Hz, that is, the inter- national A (orchestral pitch). lt is not very difficult to make an elec- tronic alternative.
It appeared that the required frequency can be derived from a readily available 1 MHz crystal which, by means of a trimmer, can be pulled to 1,000,120 Hz which is the nearest frequency containing a whole num- ber times 440 Hz.
The oscillator output is fed to lC2 which divides; bv 227;; l2° + 25 + 26 + 27 +;,*1). practically symmetrical signal of 440 Hz is then available at output 011 of lC2.